Installing the LED daughterboard
- Align and place the LED daughterboard on the palmrest assembly [1].
- Replace the single (M2x2.5)screw securing the LED daughterboard to the palmrest assembly [2].
- Route the LED board ribbon cable over the rubber routing channel on the coin cell [1].
- Connect the LED board ribbon cable to the system board [2].
![LED daughterboard](https://dl.dell.com/content/guides/public/Html/lat7300_service_manual/images/GUID-B6CF6D98-FF05-445E-8DFB-F4394C464C8C-low.jpg)
CAUTION: Route the speaker cable [1] over the LED daughterboard and then connect it to the system board [2] to prevent damage to the speaker cables.
Data is not available for the Topic