Disconnect the keyboard cable from the system board.
Hold the sides of the palm rest securely while
pushing into the two release holes using a plastic scribe.
NOTE It takes some force to push out the keyboard through
the two release holes. Please exercise due caution.
NOTE Picture for representational purpose to show exact location
of keyboard latches. It is not necessary to remove the heat sink,
hard drive, or system board in order to access the keyboard release
holes.
Gently pry up the lower edge of the keyboard
from the computer.
Remove the keyboard away from the computer.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\