The following images indicate the location of the display assembly and provide a visual representation of the removal procedure.
Steps
Remove the singe screw (M2x3) that secures the WLAN antenna cable bracket to the system board.
Lift and remove the WLAN antenna cable bracket from the system board.
Disconnect the two antenna cables that are connected to the WLAN module on the system board.
Remove the singe screw (M2x3) that secures the display cable bracket to the system board. Lift and remove the display cable bracket from the system board.
Open the latch and disconnect the display cable from the connector on the system board.
For 2-in-1 systems, disconnect the touch cable from the connector on the system board.
Open the system to 120 degrees.
Remove the single (M2x4) screw and six (M2.5x5) screws that secure the display assembly to the computer chassis.
Lift and remove the display assembly from the computer chassis.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\