Latitude 3120/Latitude 3120 2-in-1 Service Manual

Installing the power-adapter port

Prerequisites

If you are replacing a component, remove the existing component before performing the installation procedure.

About this task

The following image indicates the location of the power-adapter port and provides a visual representation of the installation procedure.

Installing the solid-state drive.

Steps

Place the power-adapter port into the slot on the computer chassis.
Replace the two screws (M2x4) that secure the power-adapter port to the computer chassis.
Connect the power-adapter port cable to the connector on the system board.

Next steps

Install the palmrest and keyboard assembly.
Follow the procedure in after working inside your computer.