Latitude 3120/Latitude 3120 2-in-1 Service Manual

Installing the display bezel

Prerequisites

If you are replacing a component, remove the existing component before performing the installation procedure.

About this task

NOTE The following steps are for Latitude 3120 systems.

The following images indicate the location of the display bezel and provide a visual representation of the installation procedure.

Connect the cables onto the system board.

Install the system board and tighten the screws.

Steps

NOTE Push the screwdriver directly into the stickers and turn counterclockwise to replace the screws. When replacing the new display bezel, adhere the new stickers over the screws once the screws have been secured.
Align the display bezel with the display assembly. Gently snap the display bezel into place.
Replace the four screws (M2.5x3.8) to secure the display bezel on the display assembly.

Next steps

Install the display assembly.
Install the palmrest and keyboard assembly.
Follow the procedure in after working inside your computer.