Installing the display hinge
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the display hinge and provides a visual representation of the installation procedure.
![Connect the cables onto the system board.](https://dl.dell.com/content/guides/public/Html/lat3120_sm/images/GUID-329D7B2E-AB30-426D-ACF9-A9049F9778D9-low.jpg)
Steps
- Align and place the display hinges on the display assembly.
- For Latitude 3120, replace the two (M2x2.5) screws and four (M2.5x2.5) screws to secure the display hinges to the display assembly.
- For Latitude 3120 2-in-1, replace the six (M2.5x2.5) screws and four (M2x2) screws to secure the display hinges to the display assembly.
- Affix the tape from the left hinge to secure the display cable.
- Affix the tape from the right hinge to secure the WLAN antenna cables.
Data is not available for the Topic