Installing the dummy battery cell
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
NOTE The following steps are for the systems that are shipped with a 3-cell battery.
The following image indicates the location of the dummy battery cell and provides a visual representation of the installation procedure.
Steps
- Align and place the dummy battery cell into the computer chassis.
- Affix the adhesive tapes to secure the dummy battery cell to the system board.
- Replace the two screws (M2x3) to secure the dummy battery cell in place.
- Connect the battery cable to the connector on the system board.
Data is not available for the Topic