Removing the base cover
The following images indicate the location of the base cover and provide a visual representation of the removal procedure.
- Remove the eight screws (M2x4) that secure the base cover to the palm-rest and keyboard assembly.
- Loosen the three captive screws (M2x8) that secure the base cover to the palm-rest and keyboard assembly.
CAUTION Do not pull on or pry the base cover at the side where the hinges are located; doing so may damage the base cover.
NOTE Upon loosening the three captive screws (M2x8), the base cover will pop up creating a gap between the base cover and the palm-rest assembly.
- Lift the base cover; use a plastic scribe for gentle prying of the cover, if necessary.
- Disconnect the battery cable from the system board.
- Turn your computer over and press the power button for 15 seconds to drain the flea power.
Data is not available for the Topic