Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Inspiron 7706 2-in-1 Service Manual

PDF

Installing the heat sink

If you are replacing a component, remove the existing component before performing the installation procedure.

CAUTION Incorrect alignment of the heat sink can damage the system board and processor.
NOTE If either the system board or the heat sink is replaced, use the thermal pad/paste provided in the kit to ensure that thermal conductivity is achieved.

The following image indicates the location of the heat sink and provides a visual representation of the installation procedure.

Image: Installing the heat sink

  1. Align the screw holes on the heat sink with the screw holes on the system board.
  2. In sequential order (as indicated on the heat sink), tighten the four screws (M2x5.35) that secure the heat sink to the system board.
  1. Install the base cover.
  2. Follow the procedure in After working inside your computer.
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\