Procedure
- Align the screw hole on the system board with the screw hole on the
palm rest and keyboard assembly.
- Replace the
screw (M2x4) that secures the system board to the palm rest and keyboard
assembly.
- Close the right
display hinge.
- Replace the
three screws (M2.5x5) that secure the right hinge to the system board.
- Connect the power-adapter port cable and speaker cable to the system
board.
- Slide the keyboard back-light cable and keyboard cable into their
respective connectors on the system board and close the latches.
- Slide the touchpad cable and hard-drive cable into their respective
connectors on the system board and close the latches.
- Slide the I/O-board cable and finger-print reader cable into their
respective connectors on the system board and close the latch.
- Slide the power-button board cable into the connector on the system
board and close the latch.
Data is not available for the Topic