Procedure
NOTE: Ensure that the hinges
are opened to the maximum before replacing the display assembly on
palm rest and keyboard assembly.
- Slide the palm rest and keyboard assembly under the hinges on the display assembly
and close it.
- Using the alignment posts, press the hinges down on the system
board and the palm rest and keyboard assembly.
- Replace the five screws (M2.5x5) that secure the left and right hinges to the system board and palm rest and keyboard assembly.
- Route the display cable through the routing guides on the fan and
the palm rest and keyboard assembly.
- Slide the display cable to the connector on the system board and
close the latch to secure the cable.
- Press down on
the latch to connect the optical-drive connector board cable to the
optical-drive connector board.
- Press down on
the latch to connect the optical-drive connector board cable to the
system board.
Data is not available for the Topic