- Notes, cautions, and warnings
- Working inside your computer
- Removing and installing components
- Recommended tools
- Screw list
- Major components of Inspiron 7506 2-in-1 Silver
- Base cover
- Battery
- Coin-cell battery
- Memory modules
- Wireless card
- Speakers
- Heat sink
- Power-adapter port
- Touchpad
- Solid-state drive
- Fan
- I/O board
- Power-button board
- Fingerprint reader daughter-board
- Display assembly
- System board
- Palm-rest and keyboard assembly
- Drivers and downloads
- System setup
- Troubleshooting
- Getting help and contacting Dell
Inspiron 7506 2-in-1 Silver Service Manual
Installing the power-button board
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the power button with fingerprint reader and provides a visual representation of the installation procedure.
Steps
- Align and place the power button, along with its cable, on the slot of the palm-rest and keyboard assembly.
- Slide the power-button cable into the connector on the fingerprint reader-board and close the latch to secure the cable.
- Align the screw holes on the power-button bracket with the screw holes on the palm-rest and keyboard assembly.
- Replace the two screws (M1.6x2.5) that secure power-button bracket to the palm-rest and keyboard assembly.
Next steps
- Install the I/O board.
- Install the fan.
- Install the heat sink — for computers with integrated graphics card or heat sink — for computers with discrete graphics card, as applicable.
- Install the base cover.
- Follow the procedure in After working inside your computer.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\