Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Inspiron 7506 2-in-1 Silver Service Manual

PDF

Installing the M.2 2230 solid-state drive

Prerequisites

If you are replacing a component, remove the existing component before performing the installation procedure.

About this task

This computer supports two solid-state drive form factors.
  • M.2 2230
  • M.2 2280
If you are replacing the M.2 2230 solid-state drive with an M.2 2280 solid-state drive, the following images indicate where to install the solid-state drive bracket based on form factor.

Image: Move the screw mount location

The following image indicates the location of the M.2 2230 solid-state drive and provides a visual representation of the installation procedure.

Image: Installing the solid-state drive

NOTE Perform step 1 to step 3 if you are replacing the M.2 2230 solid-state drive with an M.2 2280 solid-state drive.

Steps

  1. Remove the screw (M1.6x2.5) that secures the solid-state drive bracket to the palm-rest and keyboard assembly.
  2. Turn the solid-state drive bracket at an angle of 180 degrees.
  3. Insert the solid-state drive bracket into the other solid-state drive bracket slot on the palm-rest and keyboard assembly.
  4. Replace the screw (M1.6x2.5) that secures the solid-state drive bracket to the palm-rest and keyboard assembly.
  5. Align the notch on the solid-state drive with the tab on the solid-state drive slot.
  6. Slide the solid-state drive firmly into the solid-state drive slot at an angle.
  7. Replace the screw (M2x3) that secures the solid-state drive to the solid-state drive bracket.
  8. Align the screw hole on the solid-state drive thermal bracket with the screw hole on the palm-rest and keyboard assembly.
    NOTE The solid-state drive thermal bracket is available only with solid-state drives with capacity 512 GB and 1 TB.
  9. Align the notch on the solid-state drive thermal bracket with the tab on the palm-rest and keyboard assembly and press the solid-state drive thermal bracket firmly.
  10. Replace the screw (M2x3) that secure the solid-state drive thermal bracket to the palm-rest and keyboard assembly.

Next steps

  1. Install the base cover.
  2. Follow the procedure in After working inside your computer.
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\