The following image indicates the location of the display assembly and provides a visual representation of the removal procedure.
Steps
Peel the tape that secures the display cable to the system board.
Open the latch, and disconnect the display cable from the system board and remove the display cable from the slot on the palm-rest and keyboard assembly.
Remove the four screws (M2x3.5) that secure the display hinges to the palm-rest and keyboard assembly.
Remove the two screws (M2.5x5) that secure the display hinges to the palm-rest and keyboard assembly.
Lift at an angle and slide the display assembly off the palm-rest and keyboard assembly.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\