Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Inspiron 7500 2n1 Silver Service Manual

PDF

Installing the I/O board

Prerequisites

If you are replacing a component, remove the existing component before performing the installation procedure.

About this task

The following image indicates the location of the I/O board and provides a visual representation of the installation procedure.

Image: Installing the I/O board

Steps

  1. Slide the I/O board into the slots on the palm-rest and keyboard assembly.
  2. Align the screw hole on the I/O board with the screw hole on the palm-rest and keyboard assembly.
  3. Slide the fingerprint reader-cable into the connector on the I/O board and close the latch to secure the cable.
  4. Replace the two screws (M2x3) that secures the I/O board to the palm-rest and keyboard assembly.
  5. Connect the I/O-board cable to the connector on the I/O board and close the latch to secure the cable.
  6. Adhere the tape that secures the I/O-board cable to the I/O board.
  7. Connect the coin-cell battery cable to the I/O board.
  8. Close the left display hinge.
  9. Replace the two screws (M2x3.5) that secure the left display hinge to the I/O board and palm-rest and keyboard assembly.
  10. Replace the screw (M2.5x5) that secures the left display hinge to the I/O board and palm-rest and keyboard assembly.

Next steps

  1. Install the fan.
  2. Install the base cover.
  3. Follow the procedure in After working inside your computer.
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\