Installing the display assembly
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the display assembly and provides a visual representation of the installation procedure.
![Image: Installing the display assembly](https://dl.dell.com/topics/inspiron-7500-2n1-silver-service-manual/images/GUID-6A6E621E-F9A2-4102-9F43-C43379248076-low.jpg)
![Image: Installing the display assembly](https://dl.dell.com/topics/inspiron-7500-2n1-silver-service-manual/images/GUID-402C4A35-6472-4AE4-8B77-FF2663CC3B8B-low.jpg)
Steps
- Slide the display assembly at an angle, and place the display assembly on the palm-rest and keyboard assembly.
- Replace the four screws (M2x3.5) that secure the display hinge to the palm-rest and keyboard assembly.
- Replace the two screws (M2.5x5) that secure the display hinge to the palm-rest and keyboard assembly.
- Route the display cable through the slot on the palm-rest and keyboard assembly.
- Slide the display cable into the connector on the system board and close the latch to secure the cable.
- Adhere the tape that secures the display cable to the system board.
Data is not available for the Topic