- Notes, cautions, and warnings
- Working inside your computer
- Removing and installing components
- Recommended tools
- Screw list
- Major components of Inspiron 7500 2n1 Silver
- Base cover
- Battery
- Coin-cell battery
- Memory modules
- Wireless card
- Speakers
- Heat sink
- Power-adapter port
- Touchpad
- Solid-state drive
- Fan
- I/O board
- Power-button board
- Fingerprint reader daughter-board
- Display assembly
- System board
- Palm-rest and keyboard assembly
- Drivers and downloads
- System setup
- Troubleshooting
- Getting help and contacting Dell
Inspiron 7500 2n1 Silver Service Manual
Installing the base cover
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following images indicate the location of the base cover and provide a visual representation of the installation procedure.
Steps
- Connect the battery cable to the system board.
- Adhere the tape that secures the battery cable to the system board.
- Align the screw holes on the base cover with the screw holes on the palm-rest and keyboard assembly, and then snap the base cover into place.
- Replace the six screws (M2x4) that secure the base cover to the palm-rest and keyboard assembly.
- Tighten the three captive screws that secure the base cover to the palm-rest and keyboard assembly.
Next steps
- Follow the procedure in After working inside your computer.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\