Removing the display assembly
About this task
The following image indicates the location of the display assembly and provides a visual representation of the removal procedure.
![Image: Removing the display assembly](https://dl.dell.com/topics/inspiron-7500-2n1-black-service-manual/images/GUID-6B1F902D-BE58-4E4D-B743-2C0181FEFE82-low.jpg)
![Image: Removing the display assembly](https://dl.dell.com/topics/inspiron-7500-2n1-black-service-manual/images/GUID-B64A9EC3-8AC6-43BB-9B9E-374FEAEBE10C-low.jpg)
![Image: Display assembly](https://dl.dell.com/topics/inspiron-7500-2n1-black-service-manual/images/GUID-A234E410-059F-49EB-9AFE-83F9DD0C9722-low.jpg)
Steps
- Using the pull tab, disconnect the I/O-board cable from the I/O board.
- Remove the I/O-board cable from the routing guides on the fan.
- Open the latch, and disconnect the touchscreen cable from the system board.
- Peel the tape that secures the touchscreen cable to the heat sink.
- Remove the touchscreen cable from the routing guides on the fan and palm-rest and keyboard assembly.
- Open the display at an angle of 90 degrees and place the computer at the edge of a table.
- Remove the four screws (M2x3.5) that secure the display hinges to the palm-rest and keyboard assembly.
- Remove the two screws (M2.5x5) that secure the display hinges to the palm-rest and keyboard assembly.
- Lift the display assembly off the palm-rest and keyboard assembly.
Data is not available for the Topic