Installing the power-button board
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the power-button board and provides a visual representation of the installation procedure.
![Image: Installing the power button with fingerprint reader](https://dl.dell.com/topics/inspiron-7500-2n1-black-service-manual/images/GUID-3F1B92B2-C839-4B09-98B5-1B29D83FAA31-low.jpg)
Steps
- Lift the flap to access the fingerprint reader-board.
- Align and place the power-button board, along with its cable, on the palm-rest and keyboard assembly.
- Slide the power-button board cable into the connector on the fingerprint reader-board and close the latch to secure the cable.
- Align the screw holes on the power-button board bracket with the screw holes on the palm-rest and keyboard assembly.
- Replace the two screws (M1.6x2.5) that secure power-button board bracket to the palm-rest and keyboard assembly.
Data is not available for the Topic