Installing the I/O board
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the I/O board and provides a visual representation of the installation procedure.
Steps
- Slide the I/O board into the slots on the palm-rest and keyboard assembly.
- Align the screw hole on the I/O board with the screw hole on the palm-rest and keyboard assembly.
- Replace the two screws (M2x3) that secures the I/O board to the palm-rest and keyboard assembly.
- Slide the fingerprint reader-cable into the connector on the I/O board and close the latch to secure the cable.
- Connect the I/O-board cable to the I/O board.
- Connect the coin-cell battery cable to the I/O board.
- Adhere the tape that secures the fingerprint reader-cable to the I/O board.
- Close the left display hinge.
- Replace the two screws (M2x3.5) that secure the left display hinge to the I/O board and palm-rest and keyboard assembly.
- Replace the screw (M2.5x5) that secures the left display hinge to the palm-rest and keyboard assembly.
Data is not available for the Topic