Inspiron 7500 2n1 Black Service Manual

Installing the display assembly

1. Open the hinges to 90 degrees, and place the display assembly on the palm-rest and keyboard assembly.
2. Replace the four screws (M2x3.5) that secure the display hinges to the palm-rest and keyboard assembly.
3. Replace the two screws (M2.5x5) that secure the display hinges to the palm-rest and keyboard assembly.
4. Close the display, and turn the computer over.
5. Route the display cable through the routing guides on the fan and palm-rest and keyboard assembly.
6. Adhere the tape that secures the touchscreen cable to the palm-rest and keyboard assembly.
7. Slide the touchscreen cable into the connector on the system board and close the latch to secure the cable.
8. Adhere the tape that secures the touchscreen cable to the heat sink.
9. Route the I/O-board cable through the routing guides on the fan.
10. Connect the I/O-board cable to the connector on the I/O board.