Installing the power-adapter port
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the power-adapter port and provides a visual representation of the installation procedure.
![Image: Installing the power-adapter port](https://dl.dell.com/topics/inspiron-7500-2n1-black-service-manual/images/GUID-92A7C847-90C5-4DC2-AED2-899A3908AF05-low.jpg)
Steps
- Place the power-adapter port, along with its cable, into the slot on the palm-rest and keyboard assembly.
- Route the power-adapter port cable through the routing guide on the palm-rest and keyboard assembly.
- Replace the screw (M2x3) that secures the power-adapter port to the palm-rest and keyboard assembly.
- Connect the power-adapter port cable to the system board.
- Close the right display hinge.
- Replace the two screws (M2x3.5) that secure the right display-hinge to the system board and palm-rest and keyboard assembly.
- Replace the screw (M2.5x5) that secures the right display-hinge to the system board and palm-rest and keyboard assembly.
Data is not available for the Topic