Installing the pen-garage cable
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the pen-garage cable and provides a visual representation of the installation procedure.
![Image: Installing the stylus connector](https://dl.dell.com/topics/inspiron-7500-2n1-black-service-manual/images/GUID-48C8C481-3689-4C7C-8B98-37E3C87BFAEB-low.jpg)
Steps
- Align the screw hole on the pen-garage cable with the screw hole on the palm-rest and keyboard assembly.
- Replace the screw (M1.6x2.5) that secures the pen-garage cable to the palm-rest and keyboard assembly.
- Adhere the tape to secure the pen-garage cable to the system board.
- Connect the pen-garage cable to the system board.
Data is not available for the Topic