Adhere the tape that secures the battery cable to the connector on the system board, if applicable.
Place the base cover on the palm-rest and keyboard assembly, and
snap the base cover into place starting from the power-adapter port.
CAUTION To avoid accidental damage to the power-adapter port,
do not press the base cover against the power-adapter port when you
snap the base cover to the computer base.
Replace the seven screws (M2.5x6) that secure the base cover to the
palm-rest and keyboard assembly.
Tighten the two captive screws that secure
the base cover to the palm-rest and keyboard assembly.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\