NOTE Ensure that the hinges
are opened to 90 degrees before replacing the display assembly on
the palm-rest and keyboard assembly.
With the palm-rest and keyboard assembly at the edge of the table, align the screw holes on the palm-rest and keyboard assembly with the screw holes on the display hinges.
Replace the six screws (M2.5x5) that secure the left and the right hinges to the system board and the palm-rest and keyboard assembly.
Close the display and place the computer on a clean and flat surface.
Route the antenna cables on the palm-rest and keyboard assembly.
Route the display cable through the routing guides on the fan and
the palm-rest and keyboard assembly.
Slide the display cable to the connector on the system board and
close the latch to secure the display cable.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\