Remove the six screws (M2.5x2.5) that secure the display panel to the
display back-cover and antenna assembly.
Loosen the two screws (M2x3) that secure the display panel to the
display back-cover and antenna assembly.
Lift the display panel and turn it over.
NOTE Do not pull and release the Stretch (SR) Tapes from the display panel. The display hinges and brackets are shipped together with the display panel as an assembly and do not need to be separated from the display panel.
Peel the tape adhering the display cable to the back of the display
panel.
Lift the latch and disconnect the display cable from the display-panel
cable connector.
Lift the display panel away from the display back-cover and antenna
assembly.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\