NOTE Ensure that the touchpad
is aligned with the guides available on the palm-rest and keyboard
assembly, and the gap on either sides of the touchpad is equal.
Using the alignment post, slide and place
the touchpad into the slot on the palm-rest and keyboard assembly.
Replace the two screws (M1.6x2) that secure the touchpad to the palm-rest and keyboard assembly.
Place the touchpad bracket on the palm-rest and keyboard assembly.
Replace the three screws (M1.6x2) that secure the touchpad to the palm-rest and keyboard assembly.
Slide the touchpad cable into the connector on
the system board and close the latch to secure the cable.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\