Inspiron 5593 Service Manual

PDF

Procedure

Open the latch and disconnect the display cable from the system board.
Note the display-cable routing and remove the cable from its routing guides on the fan and the palm-rest and keyboard assembly.
Remove the antenna cables from the routing guide.
Open the display at an angle of 90 degrees and place it on the edge of the table in a position that allows access to the screws on the display hinges.
Remove the six screws (M2.5x5) that secure the left and the right hinges to the system board and the palm-rest and keyboard assembly.
NOTE Hold the display assembly so that it does not fall off when the last screw is removed.
Lift the display assembly off the palm-rest and keyboard assembly.
After performing all the above steps, you are left with display assembly.