Procedure
- Align the screw holes on the hard-drive bracket
with the screw holes on the hard drive.
- Replace the four screws (M3x3) that secure the hard-drive
bracket to the hard drive.
- Connect the interposer to the hard-drive assembly.
- Using the alignment posts, place the hard-drive assembly on the palm-rest and keyboard assembly.
- Replace the three screws (M2x3) that secure the hard-drive
assembly to the palm-rest and keyboard assembly.
- Connect the hard-drive cable to the system
board and close the latch to secure the cable.
Data is not available for the Topic