- Notes, cautions, and warnings
- Working inside your computer
- Removing and installing components
- Recommended tools
- Screw list
- Base cover
- Battery
- Memory modules
- Wireless card
- Fan
- Solid-state drive/Intel Optane
- Hard drive
- Touchpad
- Speakers
- Heat sink
- Display assembly
- Power-adapter port
- I/O board
- Coin-cell battery
- Power button
- System board
- Power button with fingerprint reader
- Palm-rest and keyboard assembly
- Display bezel
- Camera
- Display panel
- Display cable
- Display back-cover and antenna assembly
- Device drivers
- System setup
- Troubleshooting
- Getting help and contacting Dell
Inspiron 5593 Service Manual
Procedure
NOTE If the rubber grommets are pushed out when removing the speakers, push them back in before replacing the speakers.
- Connect the speaker cable to the system board.
- Using the alignment posts and the rubber grommets, place the speakers
in the slots on the palm-rest and keyboard assembly and route the speaker cables along the routing guides.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\