Installing the power-adapter port
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The figure indicates the location of the power-adapter port and provides a visual representation of the installation procedure.
Steps
- Place the power-adapter port into the slot on the palm-rest and keyboard assembly.
- Replace the screw (M2x3) that secures the power-adapter port to the palm-rest and keyboard assembly.
- Route the power-adapter port cable along the routing guide on the system board.
- Connect the power-adapter port cable to the system board.
- Adhere the tape to secure the power-adapter port cable to the system board.
- Lower the right display-hinge plate and ensure that the screw holes are aligned with the screw holes on the system board.
- Replace the screw (M2.5x3.5) and the two screws (M2.5x5) that secure the right display hinge to the system board.
Data is not available for the Topic