Installing the fan
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The figure indicates the location of the fan and provides a visual representation of the installation procedure.
![Image: Installing the fan](https://dl.dell.com/topics/inspiron-5502-service-manual/images/GUID-9DDA7285-8FA3-4595-8D62-523BD02377FE-low.jpg)
Steps
- Place the fan on the palm-rest and keyboard assembly.
- Align the screw holes on the fan with the screw holes on the palm-rest and keyboard assembly.
- Replace the two screws (M2x2) that secure the fan to the palm-rest and keyboard assembly.
- Route the I/O-board cable through the routing guides on the fan.
- Connect the fan cable to the system board.
- Connect the I/O-board cable to the system board and close the latch.
- Adhere the tape that secures the I/O-board cable to the system board.
- Adhere the mylar that covers the fan cable.
Data is not available for the Topic