Removing the display assembly
About this task
The figure indicates the location of the display assembly and provides a visual representation of the removal procedure.
Steps
- Peel off the tape that secures the display cable to the system board.
- Open the latch, and disconnect the display cable from the system board.
- Remove the screw (M2.5x3.5) and the two screws (M2.5x5) that secure the right display hinge to the system board.
- Remove the three screws (M2.5x5) that secure the left display hinge to the system board.
- Lift the palm-rest and keyboard assembly up to raise the display hinges.
- Slide the palm-rest and keyboard assembly carefully off the display assembly.
NOTE To avoid damaging the display, do not slide the palm-rest and keyboard assembly over the display assembly.
Data is not available for the Topic