Installing the display assembly
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The figure indicates the location of the display assembly and provides a visual representation of the installation procedure.
![Image: Installing the display assembly](https://dl.dell.com/topics/inspiron-5502-service-manual/images/GUID-67AF8203-ED23-4798-A152-560190EC0119-low.jpg)
![Image: Installing the display assembly](https://dl.dell.com/topics/inspiron-5502-service-manual/images/GUID-AFBE44C3-CECC-495E-A1C7-171A8E6A0B6D-low.jpg)
Steps
- Place the display assembly on a clean and flat surface.
- Align and slide the palm-rest and keyboard assembly under the display hinges.
NOTE To avoid damaging the display, do not slide the palm-rest and keyboard assembly over the display assembly.
- Press down the display hinges and align the screw holes on the display hinges with the screw holes on the palm-rest and keyboard assembly.
- Replace the screw (M2.5x3.5) and the two screws (M2.5x5) that secure the right display hinge to the system board.
- Replace the three screws (M2.5x5) that secure the left display hinge to the system board.
- Connect the display cable to the system board, close the latch, and adhere the tape that secures the display cable to the system board.
Data is not available for the Topic