NOTE: When removing screws from a component, it is recommended to note the screw type, the quantity of screws, and then place them in a screw storage box. This is to ensure that the correct number of screws and correct screw type is restored when the component is replaced.
NOTE: Some computers have magnetic surfaces. Ensure that the screws are not left attached to such surface when replacing a component.
NOTE: Screw color may vary with the configuration ordered.
Table 1. Screw listScrew list
Component
Secured to
Screw type
Quantity
Screw image
Base cover
Palm-rest and keyboard assembly
M2x4
7
NOTE: Screw color may vary depending on the configuration ordered.
Solid-state drive bracket
Palm-rest and keyboard assembly
M2x3
1
Solid-state drive (slot one)
Palm-rest and keyboard assembly
M2x3
1
Solid-state drive (slot two)
Palm-rest and keyboard assembly
M2x3
1
Wireless-card bracket
System board
M2x3
1
Battery (3-cell)
Palm-rest and keyboard assembly
M2x3
4
NOTE: Screw color may vary depending on the configuration ordered.
Battery (4-cell)
Palm-rest and keyboard assembly
M2x3
5
NOTE: Screw color may vary depending on the configuration ordered.
Fan
Palm-rest and keyboard assembly
M2x2
2
Left hinge
Palm-rest and keyboard assembly
M2.5x5
M2.5x3.5
2
1
Right hinge
Palm-rest and keyboard assembly
M2.5x5
3
Power-adapter port
Palm-rest and keyboard assembly
M2x3
1
Power button with fingerprint reader (optional)
Palm-rest and keyboard assembly
M1.6x2
2
Touchpad bracket
Palm-rest and keyboard assembly
M2x2
5
I/O board
Palm-rest and keyboard assembly
M2x2
2
USB 3.2 Gen 1 Type-C port bracket
System board
M2x5
2
System board
Palm-rest and keyboard assembly
M2x2
2
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\