Installing the power button with optional fingerprint reader
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The figure indicates the location of the power button with optional fingerprint reader and provides a visual representation of the installation procedure.
Steps
Using the alignment post, place the power button on the palm-rest and keyboard assembly.
Replace the screw (M1.6x2) that secures the power button to the palm-rest and keyboard assembly.
Connect the power-button cable (or the optional fingerprint-reader cable) to the connector on palm-rest and keyboard assembly.
Align the screw hole on the power-button bracket with the screw hole on the palm-rest and keyboard assembly.
Replace the screw (M1.6x2) that secures the power-button bracket to the palm-rest and keyboard assembly.