Installing the power-adapter port
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The figure indicates the location of the power-adapter port and provides a visual representation of the installation procedure.
![Image: Installing th epower-adapter port](https://dl.dell.com/topics//inspiron-15-5501-service-manual/images/GUID-3A50FBB4-5189-41AD-92C7-3A6AE1E71826-low.jpg)
Steps
- Place the power-adapter port into the slot on the palm-rest and keyboard assembly.
- Replace the screw (M2x3) that secures the power-adapter port to the palm-rest and keyboard assembly.
- Route the power-adapter port cable along the routing guide.
- Connect the power-adapter port cable to the system board.
- Adhere the tape to secure the power-adapter port cable to the system board.
- Lower the left display-hinge plate and ensure that the screw holes are aligned with the screw holes on the system board.
- Replace the screw (M2.5x3.5) and the two screws (M2.5x5) that secure the left display hinge to the system board.
Data is not available for the Topic