Installing the base cover
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The figure indicates the location of the base cover and provides a visual representation of the installation procedure.
Steps
- Connect the battery cable to the system board, if applicable.
- Place the base cover over the palm-rest and keyboard assembly.
- Align the screw holes on the base cover with the screw holes on the palm-rest and keyboard assembly, and then snap the base cover into place.
- Tighten the two captive screws that secure the base cover to the palm-rest and keyboard assembly.
- Replace the seven screws (M2x4) that secure the base cover to the palm-rest and keyboard assembly.
Data is not available for the Topic