Installing the system board
(Cirrus Logic audio controller)
Prerequisites
If you are replacing a component, remove the existing component before performing the installation process.
About this task
NOTE:This procedure only applies if you're installing a system board with a Cirrus Logic CS8409 audio controller into your computer.
The following images indicate the connectors on the system board.
NOTE:This system board supports the 10th Generation Intel Core i3 processor.
NOTE:This system board supports the following processors:
- Intel Celeron
- Intel Pentium Gold
- 11th Generation Intel Core i3/i5/i7
- Power-adapter port connector
- Speaker connector
- Keyboard connector
- Keyboard-backlight connector
- Touchpad connector
- Battery connector
- Hard-drive connector
- I/O-board connector
- Fingerprint-reader connector
- Power-button connector
The following images indicate the location of the system board and provides a visual representation of the installation procedure.
NOTE:This system board supports the 10th Generation Intel Core i3 processor.
NOTE:This system board supports the following processors:
- Intel Celeron
- Intel Pentium Gold
- 11th Generation Intel Core i3/i5/i7
Steps
- Place the system board on the palm-rest and keyboard assembly.
- Align the screw holes on the system board to the screw holes on the palm-rest and keyboard assembly.
- Replace the two screws (M2x4) that secure the system board to the palm-rest and keyboard assembly.
- Adhere the Mylar over the system-board screw that secures the system board to the palm-rest and keyboard assembly.
- Connect the speaker cable to the system board.
- Connect the keyboard cable to the connector on the system board and close the latch.
- Connect the keyboard-backlight cable to the connector on the system board and close the latch, if applicable.
- Connect the touchpad cable to the connector on the system board and close the latch.
- Connect the hard-drive cable to the connector on the system board and close the latch, if applicable.
- Connect the I/O-board cable to the connector on the system board and close the latch.
- Connect the fingerprint-reader cable to the connector on the system board and close the latch, if applicable.
- Connect the fan cable to the system board.
- Connect the power-adapter port cable to the system board.
Data is not available for the Topic