- Notes, cautions, and warnings
- Working inside your computer
- Removing and installing components
- Recommended tools
- Screw list
- Major components of Inspiron 3501
- Base cover
- Solid-state drive
- Memory module
- Wireless card
- Battery
- Hard drive
- I/O board
- Coin-cell battery
- Speakers
- Heat sink (integrated graphics)
- Heat sink (discrete graphics)
- Fan
- Power button with optional fingerprint reader
- Fingerprint-reader board
- Display assembly
- Display bezel
- Display panel
- Camera
- Touchpad
- System board
- Power-adapter port
- Palm-rest and keyboard assembly
- Drivers and downloads
- System setup
- Troubleshooting
- Getting help and contacting Dell
Inspiron 3501 Service Manual
Installing the display bezel
Prerequisites
About this task
The following images indicate the location of the display bezel and provides a visual representation of the installation procedure.
Steps
- Place the display panel and display assembly on a clean and flat surface.
- Place the display bezel on the display assembly.
- Align the tabs on the display bezel to the slots on the display assembly.
- Press down on the display bezel and snap the display bezel in place.
Next steps
- Install the display assembly.
- Install the wireless card.
- Install the base cover.
- Follow the procedure in After working inside your computer.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\