Connect the battery cable to the system board, if applicable.
CAUTION: : To avoid accidental damage to the power-adapter port,
do not press the base cover against the power-adapter port when you
snap the base cover to the computer base.
Adhere the tape that secures the battery cable to the system board.
Align and place the base cover on the palm-rest and keyboard assembly.
Snap the base cover into place.
Replace the seven screws (M2.5x5) that secure the base cover to the
palm-rest and keyboard assembly.
Tighten the
two captive screws that secure the base cover to the palm-rest and
keyboard assembly.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\