- Notes, cautions, and warnings
- Copyright
- Working inside your computer
- Removing and installing components
- Recommended tools
- Screw list
- Disassembly and reassembly
- Base cover
- Battery
- Memory modules
- Wireless card
- Coin-cell battery
- Fan
- Heat sink
- Solid-state drive/Intel Optane
- Hard drive
- Touchpad
- Speakers
- I/O board
- Display assembly
- Power-button board
- System board
- Power button with fingerprint reader
- Power-adapter port
- Palm-rest and keyboard assembly
- Display bezel
- Camera
- Display panel
- Display hinges
- Display cable
- Display back-cover and antenna assembly
- Device drivers
- System setup
- Troubleshooting
Inspiron 5494 Service Manual
Procedure
- Align the screw holes on the fan with the screw holes on to the palm-rest and keyboard board assembly.
- Route the display cable through the routing guides on the fan.
- Replace the two screws (M2.5x5) that secure the fan to the palm-rest and keyboard board assembly.
- Connect the
fan cable to the system board.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\