Procedure
- Loosen the two
captive screws on the base cover.
- Remove the seven screws (M2.5x5) that secure the base cover to
the palm-rest and keyboard assembly.
- Pry the base
cover from the top-right corner of the palm-rest and keyboard assembly.
- Lift the base cover off the palm-rest and keyboard assembly from the right side of the base cover.
![Image: Removing the base cover](https://dl.dell.com/topics//inspiron-5494-service-manual/images/GUID-D367393A-D6FF-4E86-9B55-B23A7B0798F7-low.jpg)
NOTE: : The following steps
are applicable only if you want to further remove any other component
from your computer.
- Peel the tape that secures the battery cable to the system board.
- Disconnect the
battery cable from the system board.
- Press and hold the power button for 5 seconds to ground the computer and drain the flea power.
Data is not available for the Topic