Removing the I/O board
About this task
The following image indicates the location of the I/O-board and provides a visual representation of the removal procedure.
Steps
- Remove the two screws (M2.5x5) that secure the left-display hinge to the palm-rest and keyboard assembly.
- Open the left-display hinge at an angle of 90 degrees.
- Peel the tape that secures the I/O-board cable to the I/O board.
- Open the latch, and disconnect the I/O-board cable from the I/O board.
- Open the latch, and disconnect the fingerprint reader-cable from the I/O board.
- Disconnect the coin-cell battery cable from the I/O board.
- Remove the screw (M2x3) that secures the I/O board to the palm-rest and keyboard assembly.
- Slide and lift the I/O board off the palm-rest and keyboard assembly.
Data is not available for the Topic