Installing the power-adapter port
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the power-adapter port and provides a visual representation of the installation procedure.
![Image: Installing the power-adapter port](https://dl.dell.com/content/guides/public/Html/inspiron-5406-2n1-service-manual/images/GUID-9C7955EA-F668-4E48-9097-C4F57FB01926-low.jpg)
Steps
- Place the power-adapter port into the slot on the palm-rest and keyboard assembly.
- Replace the screw (M2x3) that secures the power-adapter port to the palm-rest and keyboard assembly.
- Route the power-adapter port cable through the routing guide on the palm-rest and keyboard assembly.
- Connect the power-adapter port cable to the system board.
- Adhere the tape that secures the power-adapter port cable to the system board.
- Close the right display-hinge.
- Replace the three screws (M2.5x5) that secure the right display-hinge to the palm-rest and keyboard assembly.
Data is not available for the Topic