If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the power button with fingerprint reader and provides a visual representation of the installation procedure.
Steps
Align and place the power button, along with its cable, on the slot of the palm-rest and keyboard assembly.
Slide the power-button cable into the connector on the fingerprint reader-board and close the latch to secure the cable.
Connect the fingerprint reader-cable to the connector on the I/O board and close the latch to secure the cable.
Connect the I/O-board cable to the connector on the I/O board and close the latch to secure the cable.
Adhere the tape that secures the I/O-board cable to the I/O board.
Align the screw holes on the power-button bracket with the screw holes on the palm-rest and keyboard assembly.
Replace the two screws (M2x3) that secure power-button bracket to the palm-rest and keyboard assembly.