Installing the touchpad
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the touchpad and provides a visual representation of the installation procedure.
![Image: Installing the touchpad.](https://dl.dell.com/content/guides/public/Html/inspiron-5406-2n1-service-manual/images/GUID-A762969D-7B99-4D72-8509-C1B6149152DA-low.jpg)
Steps
- Slide the touchpad into the slot on the palm-rest and keyboard assembly.
- Replace the two screws (M2x2) that secure the touchpad to the palm-rest and keyboard assembly.
- Adhere the tape that secures the touchpad to the palm-rest and keyboard assembly.
- Slide the touchpad cable into the connector on the touchpad and close the latch to secure the cable.
- Place the touchpad bracket into the slot on the palm-rest and keyboard assembly.
- Replace the three screws (M2x2) that secure the touchpad bracket to the palm-rest and keyboard assembly.
Data is not available for the Topic