Installing the touchpad
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the touchpad and provides a visual representation of the installation procedure.
![Image: Installing the touchpad](https://dl.dell.com/topics/inspiron-5402-service-manual/images/GUID-F6A9794E-3F91-491C-9D1F-5F8636C1DF03-low.jpg)
Steps
- Align and place the touchpad into the slot on the palm-rest and keyboard assembly.
- Replace the two screws (M2x2) and adhere the tape that secures the touchpad to the palm-rest and keyboard assembly.
- Adhere the tape to secure the touchpad to the palm-rest and keyboard assembly.
- Align and place the touchpad bracket into the slot on the palm-rest and keyboard assembly.
- Replace the three screws (M1.6x2) that secure the touchpad bracket to the palm-rest and keyboard assembly.
- Connect the touchpad cable to the system board and close the latch.
Data is not available for the Topic