The following images indicate the location of the base cover and provide a visual representation of the removal procedure.
NOTE The following image may differ slightly, depending if your computer is shipped with a fingerprint reader on the power button.
Steps
Remove the screw (M2x2) that secures the power-button bracket to the palm-rest and keyboard assembly.
Lift the power-button bracket off the palm-rest and keyboard assembly.
Remove the two screws (M2x2.5) that secure the power button to the palm-rest and keyboard assembly.
Peel the tape that secures the power-button cable to the palm-rest and keyboard assembly.
Lift the fingerprint-reader board (if applicable) off the palm-rest and keyboard assembly.
Lift the power button with optional fingerprint-reader (if applicable), along with the fingerprint-reader cable (if applicable), off the palm-rest and keyboard assembly.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\