Installing the power-adapter port
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the power-adapter port and provides a visual representation of the installation procedure.
Steps
- Place the power-adapter port into the slot on the palm rest and keyboard assembly.
- Replace the screw (M2x3) that secures the power-adapter port on the palm-rest and keyboard assembly.
- Route the power-adapter port cable through the routing guides on the palm-rest and keyboard assembly.
- Connect the power-adapter port cable to the system board.
- Press down the right display-hinge and align the screw holes on the display hinges with the screw holes on the system board.
- Replace the two screws (M2.5x5) that secure the right display-hinge to the system board.
Data is not available for the Topic